If you have a modern wireless Cisco Access Point like a 2702 or an 1130, you will likely want (or need) to know what the LED status light is trying to tell you. Below are the what the LED codes mean.
When the power up sequence is complete:
- the LED displays a light green color to indicate that it is ready for operation.
- the LED displays a blue light when a client associates to the access point.
- the LED displays an amber light to indicate a problem, such as when the access point is unable to verify that the PSE is supplying sufficient power.
See the “Configuring Power” section on page 17 of THIS Cisco document you see an amber light.
3 Comments
Avery Wright · January 16, 2019 at 8:05 am
Are you using a Cisco Wireless Controller? I’m not absolutely sure, but I don’t know of any Cisco AP’s that will work without the separate controller.
Abdus-Sabur Oliyide · August 30, 2017 at 9:32 am
Am trying to configure a Cisco 2600 Aironet Access Point. Am using Putty platform for my command line console on USB to Serial Port (COM14). Each time open the putty the cursor dose not respond and I can’t move on. Please help. What can I do. Thanks
Ian Matthews · December 28, 2017 at 11:39 am
Have you tried setting different speeds?
I have see a few bad Cisco Aironet routers that I cannot get to respond. The unit MIGHT be defective.